Smooth per-pixel PBR metallic shading with authentic machined details from AMF Reece Catalog Pages 18–21: tapered wide-flat hollow Needle Bar, 4-bolt Vibrator Cap, laminated brass shims, slotted shoulder screws, spanner nut notches, and 24-tooth bevel gear.
Size of Roll is etched on both sides of Stitch Cam (For oversized cam slots):
Sandwiched between Vibrator Block (#10-1026-2) and 4-Bolt Cap (#10-1065):
• Needle Bar Adjustment (Sheet 1-14 Fig. 6 & 7): “Turn the R.H. handwheel (knurled rim) until the needle bar has risen 3/32" from its lowest point. In this position the eye of the needle should be about 3/32" below the looper. Loosen the screws (6, #10-1027-1-050) and raise or lower the needle bar (7, #10-1028-2) to suit.”
• Split Collar Yoke Play (Sheet 1-15 Fig. 1): “This yoke (1, #10-1046-2) must be adjusted to work smoothly but without excessive play. Part (2, #10-1016-2) is a nut — loosen screw (3, #01-2419) and screw up nut (2) to suit.”
• Trouble Digest 21-T (Button Sticking): “Vibrator Block 10-1026-2 sticking due to extreme pressure of Buttons 10-1025-1 on Needle Bar flats. Locate the cause and remove pressure. Buttons should bear very lightly against the flats.”